Home / Topics / Food and nutrition
Food and nutrition · How-to
How to make jerky safely at home
Drying alone doesn’t make raw meat safe. Heating it to 160°F does.
Safety numbers are quoted, not invented. Every dose, time, temperature, and ratio on this page is copied from the agency named beside it. Where agencies differ, we show each one with its source instead of picking. If your local health department or officials give different instructions, follow them.
Why this matters. USDA warns that harmful bacteria are likely to survive the dry heat of a warm oven, and especially the 130–140°F of a food dehydrator, if raw meat is simply dried. After drying, bacteria become much more heat resistant.[1] Marinating alone doesn’t make raw meat safe.[1]
The key rule: heat the meat to 160°F
- USDA: heat meat to 160°F and poultry to 165°F, measured with a food thermometer, before dehydrating. Then dry at a constant 130°F to 140°F.[1]
- NCHFP gives two ways to reach an internal 160°F without “case hardening”: heat the strips in their marinade before drying, or heat the dried strips in an oven afterward.[2]
Safe handling first
- Wash hands with soap and running water for at least 20 seconds before and after handling raw meat.[2]
- Use clean equipment. Keep meat at 40°F or below. Use ground beef and poultry within 2 days and whole red meats within 3 to 5 days, or freeze them.[1]
- Thaw and marinate in the refrigerator. Don’t re-use marinade.[1]
- Pork or wild game: freeze a portion 6 inches thick or less at 0°F or below for at least 30 days before slicing, to kill the trichinella parasite. Freezing does not kill bacteria.[2]
- Wild game: venison can be heavily contaminated with fecal bacteria, depending on the shot and the field dressing. If gut contents touched the meat, NCHFP advises not making jerky from it.[1][2]
Steps (NCHFP method)
- Slice. Partially freeze the meat for easier slicing. Cut it no thicker than ¼ inch and trim off all fat, which goes rancid quickly. Slice with the grain for chewy jerky, or across it for tender jerky.[2]
- Marinate in the refrigerator, 1 to 2 hours or overnight.[2]
- Heat (Option A): at the end of marinating, bring the strips and marinade to a boil and boil for 5 minutes before draining. Thicker strips may need longer. If you can, check several strips with a thermometer for 160°F.[2]
- Dry. Drain the strips and lay them close together but not touching on dehydrator trays, or on racks over baking sheets in an oven, preheated to 140°F. Dry until a test piece cracks but doesn’t break when bent. That takes 10 to 24 hours for strips not heated in marinade. Pre-heated strips dry faster, so start checking after 3 hours.[2]
- Heat (Option B): if you skipped Option A, heat the dried strips on a baking sheet for 10 minutes in an oven preheated to 275°F. That’s for strips cut ¼ inch thick or less. Thicker strips may need longer to reach 160°F.[2]
- Cool and pack. Pat off beads of oil, cool, and pack in glass jars or heavy plastic bags. Vacuum packaging is a good option too.[2]
USDA’s guidance on dehydrators: use one with an adjustable temperature dial that holds at least 130°F to 140°F throughout drying.[1] Don’t sun-dry meat jerky.[1]
Ground-meat jerky
Germs are harder to eliminate in ground meat than in whole strips. Follow the dehydrator manufacturer’s heating directions, and make sure it reaches an internal 160°F.[2]
How long it keeps: two official answers
| Source | Home-dried jerky |
|---|---|
| USDA FSIS[1] | Can be stored 1 to 2 months (commercially packaged: 12 months) |
| NCHFP[2] | Keeps at room temperature two weeks in a sealed container. Refrigerate or freeze it for longer shelf life and best quality. |
For emergency storage, NCHFP’s shorter figure is the cautious choice. Freeze what you won’t eat soon.
Sources
- USDA Food Safety and Inspection Service: Jerky and Food Safety
- National Center for Home Food Preservation: Jerky
Official pages checked 14 November 2026. Guidance changes; follow your local officials first. How we research.
Page checked on · Change log · Report an error · Calm by design