Water · How-to
Water filters, tablets, and other ways to treat water
What each method can and cannot do, according to CDC, EPA, and Ready.gov.
Safety numbers are quoted, not invented. Every dose, time, temperature, and ratio on this page is copied from the agency named beside it. Where agencies differ, we show each one with its source instead of picking. If your local health department or officials give different instructions, follow them.
Boiling and bleach are the first choices. These other methods are useful backups, and some work best in combination. Ready.gov notes that often the best solution is a combination of methods.[1]
At a glance
| Method | Kills germs? | Removes chemicals, metals, salts? | Notes |
|---|---|---|---|
| Boiling[1] | Yes | No | CDC: best way to kill germs |
| Chlorination (bleach) | Yes | No | Less effective on Giardia and Cryptosporidium (CDC) |
| Distillation | Yes | Yes (heavy metals, salts, most other chemicals) | Slow; uses fuel |
| Portable filter[2] | Depends on pore size; will not remove viruses | Not covered by CDC guidance | Follow with a chemical disinfectant |
| UV light or sunlight[2] | Reduces germs in clear water | No | Clear water only |
Portable water filters
CDC says portable filters do not remove all types of germs:[2]
- They will not remove viruses.
- To remove bacteria, a filter must have an absolute pore size of 0.3 micron or smaller.
- To remove parasites such as Giardia or Cryptosporidium, it must have an absolute pore size of 1 micron or smaller.[2]
How to use one: follow the filter’s instructions. After filtering, add a chemical disinfectant such as iodine, chlorine, or chlorine dioxide to kill any viruses and bacteria.[2] When you shop, look for the “absolute” pore size on the package, not a vague claim.
Disinfection tablets and drops
- Follow the instructions on the package. Products are made for specific amounts of water and may differ in strength.[2][3]
- Chemical disinfectants kill viruses and bacteria but may not kill parasites. Iodine and chlorine tablets will not kill Cryptosporidium. Chlorine dioxide tablets will, as long as you follow the instructions correctly.[2]
Iodine: the agencies disagree
- EPA lists household tincture of iodine as an option: five drops of 2% tincture of iodine per quart or liter, or 10 drops if the water is cloudy or colored. Stir and let stand at least 30 minutes.[3]
- CDC says to avoid iodine-treated water if you are pregnant, have thyroid problems, or are sensitive to iodine. CDC also says no one should drink it for more than a few weeks at a time.[2]
- Ready.gov (2021) says iodine and camping treatment products that don’t contain 5.25–6% sodium hypochlorite as the only active ingredient are not recommended and should not be used.[1]
Given the disagreement, treat iodine as a last resort and keep bleach or chlorine dioxide tablets as your main chemical backup.
Distillation
Distillation removes germs that resist boiling and chlorine. It also removes heavy metals, salts, and most other chemicals.[1] Ready.gov’s method:[1]
- Fill a pot halfway with water.
- Tie a cup to the handle on the pot’s lid so the cup hangs right-side-up when the lid is upside down. Make sure the cup doesn’t dangle in the water.
- Boil the water for 20 minutes.
- The water that drips from the lid into the cup is distilled.
UV light
Portable UV units can kill germs in small amounts of clear water. They don’t work well in cloudy water. Filter or settle the water first, then follow the unit’s instructions.[2]
Solar disinfection (sunlight)
CDC says sunlight can reduce the number of germs in clear water:[2]
- Clear cloudy water first (filter or settle).
- Fill clean, clear plastic bottles with the clear water.
- Lay the bottles on their sides in the sun for 6 hours if it’s sunny, or 2 days if it’s cloudy. A dark surface underneath helps.
Calcium hypochlorite (pool shock): EPA only
EPA describes making a chlorine solution from high-test granular calcium hypochlorite (HTH). Add one heaping teaspoon (about ¼ ounce) to two gallons of water and stir until it dissolves. That makes roughly a 500 mg/L solution. Then add one part of this solution to each 100 parts of water you’re treating, which is about 1 pint (16 ounces) of solution to 12.5 gallons of water. Do this in a ventilated area and wear eye protection. EPA cautions that HTH is a very powerful oxidant, so follow the label for safe handling and storage.[3] Most households are better served by liquid bleach.
Sources
- FEMA / Ready.gov: Water
- CDC: How to Make Water Safe in an Emergency
- U.S. EPA: Emergency Disinfection of Drinking Water
Official pages checked 14 November 2026. Guidance changes; follow your local officials first. How we research.
Page checked on · Change log · Report an error · Calm by design